Ubiquiti EdgePoint S16 Quick Start Manual page 22

EdgePoint EP-S16 Quick Start Guide
™
5. When you are finished, replace the port cover and use an
S2 hex wrench to tighten the Screw and secure the port cover.
Mounting the PoE Adapter (Optional)
1. Remove the PoE Mounting Bracket from the adapter, place the
bracket at the desired location, and mark the two holes.
2. Pre-drill the holes if necessary, and secure the bracket using
two fasteners (not included).
3. Align the slots on the adapter with the tabs on the PoE
Mounting Bracket, and then slide the adapter down.
20