Power Options - Ubiquiti EdgePoint S16 Quick Start Manual

EdgePoint EP-S16 Quick Start Guide
™

Power Options

Either the VDC or PoE input type is used at any one time. If both
are connected, only the input type with the highest voltage will be
used; the other can be used as a backup.
Both PoE inputs can be used at the same time. If there is a voltage
difference, the higher-voltage source will be used first. The voltage
from the initial source will drop as the load increases. When the
voltage drops to the same level as the lower-voltage source, then
the lower-voltage source will also start providing power.
Power Input Options
• 54VDC, 6A
• 54V, 1.5A on PoE In/1
• 54V, 1.5A on PoE In/2
The number of devices that can be powered depends on the
power consumption of the specific devices. Example: If you use
54VDC, 1.5A, then you have 81W. If the EdgePoint uses 40W, then
you have 41W for PoE output. Check product specifications for the
power consumption values to use in your calculations.
Bottom Panel DC Input
Interface
VDC In
4
VDC
Description
Terminal block connector uses auto-polarity
detection and accepts +42 to +56VDC, 6A
input (including the Ubiquiti Networks
EdgePower
the EdgePoint and passive PoE output.
Power Output Options
• EdgePoint (required)
• Passive 54/24V, 4-Pair PoE on 1-4
• PoE+ or Passive 24V, 2-Pair PoE
on 5-16
, model EP-54V-150W) to power
™