Connecting To Power - Ubiquiti EdgePoint S16 Quick Start Manual

EdgePoint EP-S16 Quick Start Guide
™

Connecting to Power

Either the +42 to +56VDC input or PoE input is used at any one
time. If both input types are connected, only the input type
with the highest voltage will be used; the other can be used as a
backup. Follow the appropriate instructions for your installation:
Connecting to the 54VDC Input
1. Wire one end of the DC power cable to the VDC terminal block,
which uses auto-polarity detection.
2. Replace the port cover and use an S2 hex wrench to tighten
the Screw and secure the port cover.
3. Wire the other end of the cable to a DC power supply.
4. Connect the DC power supply to its power source.
18