Air Inlet Controls; Fuel Retainer Bars - Hamlet Solution Operating & Installation Manual

AIR INLET CONTROLS

The Hamlet Solution stoves have two air inlet
controls.
The primary air inlet providing under draught to the
base of the fire chamber through the control slider
located under the oval at the base of the fire door.
The air wash system, (secondary air) so called
because its pre-heated high speed air, washes
across the inner face of the door glass, keeping it
clear. This also provides an over draught to the
fuel bed.
PRIMARY AIR
Air enters the appliance through the control on the
bottom of the fire door. The Hamlet Solution has a
single control knob which slides left to right. Sliding
the knob to the right (+), see Fig. 13, will increase
the amount of air intake to the stove. To decrease,
push the slider to the left (-) as in Fig. 14
Fig. 13. Fully Open Position
Fig. 14. Fully Closed Position
Hamlet Solution Stoves
OPERATING INSTRUCTIONS
AIR WASH SYSTEM
The air wash has an internal sliding plate with
slots, housed in a cover plate, and is located
above the fire door. Sliding the control knob to the
right as far as it will go, achieves the fully open
position, see Fig. 15. Sliding it to the left will shut
off the air inlet slots as shown in Fig. 16.
Fig. 15. Air Wash Fully Open Position
Fig. 16. Air Wash Fully Closed Position
25