TO USE THESE FUELS WILL INVALIDATE THE APPLIANCE GUARANTEE IF IN DOUBT CONTACT THE SOLID FUEL ASSOCIATION TELEPHONE NUMBER 0800 600 000 www.solidfuel.co.uk THE USE OF SPARE PARTS OTHER THAN THOSE SUPPLIED BY HAMLET STOVES WILL INVALIDATE THE APPLIANCE GUARANTEE. Hamlet Solution Wood & Multifuel Stoves...
• Use gloves to provide additional grip. controlled by the air inlet mechanism. Hamlet Stoves are also fitted with an "air wash" so called because it provides a curtain of high speed THE PRINCIPLE OF THE FIRE preheated air behind the glass to help keep it clean and to provide secondary air/over draught.
(not to scale) 8. Rear grate bar support 9. Comb assembly consisting of comb & comb extension 10. Fuel retainers 11. Fire door han- dle - Kool Touch 12. Ashpan 13. Operating tool 14. Instruction Manual Hamlet Solution Wood & Multifuel Stoves...
*Measured from rear of canopy to the tip of the handle. The model and Serial Number of your stove can be found stamped into the casing, centrally just below the bottom edge of the fire door aperture. Hamlet Solution Wood & Multifuel Stoves...
Place appliance on the hearth and make sure that it Regulations. The minimum effective height of the is level and does not rock. The Solution range of flue must be at least 4.5 metres from the top of the stoves are fitted with adjustment cam on both rear stove to the top of the flue outlet.
/b r e g s/ br ad s. h t m NACS (National Association of Chimney Sweeps): telephone 01785 811732 Details on the relevant Building Regulations and www.chimneyworks.co.uk BS British Standards are given in the "General Hamlet Solution Wood & Multifuel Stoves...
Page 12
INSTALLATION Fig. 2. A Typical Rear Flue Layout Hamlet Solution Wood & Mutifuel Stoves...
Page 13
IEW OF REGISTER PLATE AND CLEARANCES FOR NON INSULATED FLUES A is minimum clearance for non-insulated flue = 1.5 x D to a non-combustible surface/material 3 x D to combustible surface/material Fig. 3. A Typical Top Flue Layout Hamlet Solution Wood & Multifuel Stoves...
ADJUSTING THE SELF WOOD STOVE VERSION - LEVELLING FEET WOOD TRAY The Hamlet Solution Wood and Multifuel stoves The wood burning tray should come fitted in your are equipped with adjustable rear levelling feet, stove, if not please follow these instructions - these are ideal for use where the hearth surface is •Fully open the fire door, and remove the two round...
MULTIFUEL STOVE VERSION- MULTIFUEL GRATE GRATE The grates in the Hamlet Solution multifuel units comprise a series of reciprocating cast iron bars seated on a pivoted "comb". All bars in the grate are identical, but every other bar is turned through 180 degrees, with the ends of the bars marked "H"...
INSTALLATION FIREBOX LINER PANELS The Hamlet Solution Wood and Multifuel stoves use firebox liner panels to the sides and back of the firebox. The throat plate sits on top of the side and rear panels. These should come fitted to your stove,...
OPTIONAL ADD IN BOILERS supplier will be able to offer advice and assistance. Direct Systems Hamlet Solution Wood and Multifuel stoves offer Stainless steel boilers, either factory fitted or the option of a slab boiler, which occupies the posi- retro-fitted as add-in boilers enable connection to tion of the rear firebox liner panels.
Please answer all questions as fully as Pipes should be run to avoid air locks. A spring possible. Hamlet Stoves can not be held responsi- safety valve should be fitted to the expansion pipe ble for chimney or installation.
Page 19
I/we the undersigned confirm that the above details are correct. In my opinion, these works comply with the relevant requirements in Part J of Schedule 1 to the Building regulations. Print name and title....................Profession................Capacity........................Telephone................Address................................Post code........Signed......................Date......... Hamlet Stoves Wood & Multifuel Stoves...
SERVICING & MAINTENANCE CLEANING Note: Use only genuine Hamlet Stoves touch-up spray as some paints interact. This could ruin the finish and invalidate the guarantee. INTERNAL SURFACES IMPORTANT - DOOR GLASS Under some circumstances soot can quickly build The door glass should remain clear during normal up on the throat plate and adjacent areas.
The fire door can be re-aligned by the user as all gasketing on doors, glass etc. and re-order any follows: items that may need replacing, from your Hamlet dealer. With a wire brush clean inside the appliance •When the appliance is cold, open the fire door so paying particular attention to the small inlet holes that it is at a right angle to the front face of the fire.
SERVICING & MAINTENANCE DISASSEMBLE AIRWASH The Hamlet Solution air wash may be disassembled for cleaning or adjustment. To achieve this, the following procedure should be followed: Note - This should only be carried out when the fire is cold and unlit.
(Fig. 17) Fig. 17. Lining up the gasket •Re-seat the new glass, ensuring the sealing gasket is flat and in contact with the glass. (Fig. 18) Fig. 18. Fitting the glass Hamlet Solution Wood & Multifuel Stoves...
Work Carried Out Signature Date of Visit Should you have any questions about your Solution Stove that is not covered in this manual please contact your Hamlet Stoves retailer. Please keep all repair receipts safely. Please ensure you have this manual available when an engineer visits as they will complete the service record chart.
Hetas registered installer. Stop using the appliance if you smell fumes or ANTHRACITE (Multifuel Version Only) see smoke escaping. Anthracite is more difficult to keep in for long Hamlet Solution Wood & Multifuel Stoves...
PRIMARY AIR Air enters the appliance through the control on the bottom of the fire door. The Hamlet Solution has a single control knob which slides left to right. Sliding the knob to the right (+), fig.21, will Fig.
TOOL ing tool into the ash pan and remove from the ash pit chamber. Your Hamlet stove comes with a multi-purpose Empty the ash into a suitable container and replace operating tool, which is used for riddling, setting ashpan into the stove, withdraw the operating tool the multifuel grate *, (fuel position) , adjusting the and close the fire doors.
A ‘Kooler to touch’ fire door handle is fitted to your which will create condensation and deposits in the Hamlet stove, this provides operation of the fire chimney. This effect can be minimised by burning door whilst the stove is in use. Care must be taken...
100mm. This will effect the height from the floor to the centre of the rear flue outlet, just add 100mm to rear flue outlet, see page 8 for technical information. ** - See page 17 for instructions on how to fit the add in boilers. Hamlet Solution Wood & Multifuel Stoves...
Once again we would like to thank you for buying STOVES WILL INVALIDATE a Hamlet Solution stove. APPLIANCE WARRANTY. When you buy a Hamlet stove, you are not only HAMLET STOVES WILL NOT BE buying a first class appliance - you are buying a RESPONSIBLE FOR ANY CONSEQUEN- commitment from us to look after you and your appliance for as long as you want.
Page 35
For your peace of mind Hamlet Stoves gives a Lifetime Guarantee against manufacturing defects of the main body* of its Solution range of stoves. Additionally, all other parts are covered by a one year no quibble replacement guarantee. This guarantee covers replacement of the item only and does not extend to any other costs, including labour, incurred in its replacement.
FINAL FACTORY CHECK LIST Model........Serial No......QUALITY FINISH I’ve checked it PARTS and it’s O.K. FLUE OUTLET HOT PLATE FUEL RETAINERS GRATE BARS / WOODBURNING TRAY Assembled by......FIREBOX LININGS THROAT PLATE Checked by ........ AIR WASH DOOR CATCH / KOOL TOUCH HANDLE ASH PAN ADJUSTING FEET X 2 OPERATING TOOL...
Need help?
Do you have a question about the SOLUTION and is the answer not in the manual?
Questions and answers