Air Inlet Controls (Primary / Air Wash); Fuel Retainer Bars - Hamlet BK055 Operating & Installation Manual

AIR INLET CONTROLS
The Aarrow Sherborne stoves have two air inlet
controls.
The primary air inlet providing under draught to the
base of the fire chamber through the control slider
located under the window of each fire door.
The air wash system, so called because its
-heated high speed air, washes across the inner
face of the door glass, keeping it clear. This also
provides an over draught to the fuel bed.
PRIMARY AIR
Air enters the appliance through the control on the
bottom of the fire door. The Hamlet Camborne
Deluxe has a single control knob which slide left to
right. Sliding the knob to the Left (+), see Fig.19,
will increase the amount of air intake to the stove.
To decrease, push the slider to the Right (-) as in
Fig. 20
Fig. 19. Fully Open Position
Fig. 20. Fully Closed Position
Hamlet Camborne Deluxe Stoves
OPERATING INSTRUCTIONS
AIR WASH SYSTEM
The air wash has an internal sliding plate with
slots, housed in a cover plate, and is located
above the fire door. Sliding the control knob to the
right (+) as far as it will go, achieves the fully open
position, see Fig. 21. Sliding it to the left (-) will
pre shut off the air inlet slots as shown in Fig. 22.
Fig. 21. Air Wash Fully Open Position
Fig. 22. Air Wash Fully Closed Position

FUEL RETAINER BARS

Fuel retaining bars are supplied with the stove. For
wood burning, the top fuel retaining bar may be
removed to afford a better view of the fire. Slide
and lift the bar until it is clear of the guides at each
side, and remove through the fire door opening.
The bars are symmetrical and of even lengths
making incorrect fitting impossible.
Please Note—This should be carried out when
the stove is cold and unlit.
27