Parts To Be Installed; Battery - Installation; Battery Cable Routing - Can-Am 2008 Outlander 400 EFI Shop Manual

PARTS TO BE INSTALLED

Battery
WARNING
Always connect RED positive cable first and
then BLACK negative cable.
Never charge or boost battery
CAUTION
while installed on vehicle.
NOTICE Always charge battery before its in-
stallation on the vehicle.
NOTICE Make sure not to squeeze battery ca-
bles between vehicle components.
Battery Installation
1. Refer to the latest edition of
TERIES SERVICE BULLETIN
ing, charging and maintenance procedures.
Outlander Models
2. Unhook battery retaining strap.
vbl2008-007-004_a
1. Retaining strap
2. Battery
Renegade Models
3. Unscrew battery retaining rod.
PREDELIVERY
sales@midwestmanuals.com
BATTERY RETAINING ROD
CAN-AM ATV BAT-
All Models
for proper activat-
4. Remove battery from vehicle.
5. Charge battery. Refer to
6. Install charged battery on vehicle.
7. Properly route battery cables. Refer to
8. Connect RED positive cable to positive battery
9. Connect BLACK negative cable to negative
10. Apply dielectric grease (P/N 293 550 004) on
11. Cover positive post with rubber boot.

Battery Cable Routing

routing. Refer to the following illustrations.
1. Ensure that the cable end is installed as illus-
CORRECT WAY OF SECURING POSITIVE (+) POST
2009-2
sales@midwestmanuals.com
PARTS TO BE INSTALLED
vmr2007-047-001_a
TERIES SERVICE BULLETIN
TERY CABLE ROUTING
post.
battery post.
battery posts.
NOTICE
Always respect the specific cable
trated and the cable is routed over the battery.
vbl2008-005-250_a
CAN-AM ATV BAT-
.
BAT-
below.
5 / 34