Riso ComColor 9150 User Manual page 53

Message
Insert No.
Insert data is missing.
Check the data.
(The job has been deleted.)
Insert No.
Envelope form data with a size
different from the specified size was
found. Check the settings.
(The job has been deleted.)
Some data have different envelope
sizes. Check the settings.
(The job has been deleted.)
Insert No.
This operation cannot be done due to
the inconsistent inserts size.
Check the data.
Load insert paper
in the following tray.
Selected tray:
Load the envelope form on the
standard tray with the glue side
face up (down) and the flap to right (left).
Set envelope form in the
direction below.
Standard tray:
Glue side up (down), flap right (left).
Feed tray 1-3:
Glue side down (up), flap left (right).
Load the envelope form in the
feed tray with the glue side
face down (up) and the flap to the left
(right).
Set the paper guide (end).
Check of the position of the
paper guide (end).
Action to Take
In [Details] of the mail making print, a check mark is placed in
[Insert], however, the original data for the inserts does not exist.
Otherwise, the combination of data for the envelope forms and
inserts is incorrect.
➀ Press [Close].
➁ The continue confirmation screen is displayed. Press [Close].
➂ Correct or clear the incorrect part of original data and resend
the data.
The data contains the insert data whose size is different from
the envelope form specified in [Details] of Mail making.
Otherwise, original data for the envelope forms does not exist.
Make the envelope forms for one job all the same size.
➀ Press [Close].
➁ The continue confirmation screen is displayed. Press [Close].
➂ Correct or clear the part of original data that is incorrect and
resend it.
Envelope forms with different sizes exist among one job.
Press [Close].
Correct or clear the incorrect part of original data, and resend
the data.
Inserts with different sizes exist among one job.
Press [Close].
Correct or clear the incorrect part of original data, and resend
the data.
There is no paper in the tray designated as the inserts tray or
paper with different sizes has been set.
Set the correct sized paper in the designated tray.
• Though the tray for envelope forms is set to [Auto], there is no
envelope form in the tray selected in [Tray selection].
Press [Change tray] to change the feed tray to other than
[Auto] or select the tray for envelope forms in [Tray selection].
When you [Continue] the print, check the orientation of the
envelope forms and set them in the standard tray or feed tray.
• The tray for the designated envelope forms is empty. Check
the orientation of the envelope forms, and set them in the
standard tray or the feed tray.
Alternatively press [Change tray] to change the tray for
envelope forms.
The paper guide (end) has not been set.
Set the paper guide (end).
The paper guide (end) position is incorrect.
Correct the position of the paper guide (end).
Wrapping Envelope Finisher User's Guide 05
Troubleshooting
2
2-7