Using The Go Xse In An Ap24/Ap28 System; Using The Autopilot In An Evc System - Simrad GO XSE Operator's Manual

If the value is set too high, the overshoot increases and the steering
is unstable.
Contour Cross Angle (CCA)
The CCA is an angle that is added to or subtracted from the set
course.
With this parameter you can make the boat yaw around the
reference depth with lazy-s movements.
The larger the CCA, the bigger yawing is allowed. If you the CCA set
to zero there are no lazy-s movements.

Using the GO XSE in an AP24/AP28 system

Command transfer
If your GO XSE is connected to an autopilot system including an
AP24 or AP28 control unit, only one control unit can be active at the
same time. An inactive control unit is indicated with a square with a
cross symbol in autopilot controller pop-up.
You take command from an inactive control unit by selecting the
mode in the autopilot pop-up, and then confirming active mode.
Locking remote stations
The AP24/AP28 includes a Remote Lock function that disables
autopilot control from other units. A locked control unit is indicated
with a key symbol in autopilot controller pop-up.
When the remote lock function is enabled on an AP24/AP28 control
unit, only the active control unit stays in command. No transfer of
command to GO XSE or other autopilot control units on the system
can take place.
You can only unlock the remote stations from the AP24/AP28 unit in
command.

Using the autopilot in an EVC system

When the GO XSE is connected to an EVC system via the SG05, you
can take manual control of the steering regardless of the autopilot
mode.
The mode indicator on the pilot pop-up is replaced by a dash to
indicate EVC override.
The system returns to GO XSE control in standby mode if no rudder
command is given from the EVC system within a predefined period.
85
Autopilot | GO XSE Operator Manual