Simrad GO XSE Operator's Manual page 73

You remove the pop-up from a page by selecting the X in the
upper right corner. You turn it on again by selecting the autopilot
tile in the instrument bar.
The following pop-ups are available:
Autopilot controller, showing active mode, heading, rudder
•
and various steering information depending on active autopilot
mode. Manual adjustments to the set heading can only be made
when the port and starboard arrow indicators are illuminated red
and green.
Mode selection, includes access to turn pattern selection.
•
Turn pattern selection
•
Autopilot controller
Autopilot tile in Instrument bar
You can select to show the autopilot tile in the Instrument bar.
If the autopilot pop-up is turned off you can turn it on by selecting
the tile in the Instrument bar.
The Autopilot panel
The autopilot panel is used to display navigation data. It can be
shown as a full screen panel, or in a multi-panel page.
The number of data fields included in the autopilot panel is
dependent on available panel size.
Autopilot | GO XSE Operator Manual
Mode selection Turn pattern selection
73