Sun Microsystems sun fire V20Z Installation Manual page 7

2. Install one slide-rail assembly to each side of the rack as shown in
securing them with the screws provided.
The end of the rail with the adjustable bracket must be positioned toward the back
of the rack as shown.
Note – Leave the middle screw holes on each front mounting bracket open for the thumb
screws on the server.
Rear mounting
bracket (adjustable)
Installing the Slide-Rails Into the Rack
FIGURE 1-2
3. Slide the server, with mounting brackets installed, into the rack so that the
mounting bracket bases fit inside the slide rail assemblies (see
As you slide the server into the rack, press down on the outer slide-rail locking-tab
to allow the mounting bracket to pass through.
Slide-rail
assembly
(rack posts not shown)
Installing the Slide-Rails Into the Rack
FIGURE 1-3
Slide rail assemblies
Slide-rail
locking tab
Mounting
bracket
Chapter 1 Hardware Installation and Startup
FIGURE 1-2
Front mounting
bracket
).
FIGURE 1-3
,
3