Sun Microsystems sun fire V20Z Installation Manual page 15

Back
Press both for Cancel
Operator Panel Buttons
FIGURE 2-1
2. Press the Forward button until you reach the SP menu:
Menu:
SP menu
3. Press the Select button to display the SP menu options.
SP Menu:
Set SP IP info?
4. Press the Select button.
The following prompt appears with the default response:
SP use DHCP?
No
5. Press the Forward button to change to Yes, then press the Select button.
6. Press the Select button at the confirmation prompt.
SP use DHCP:
Yes?
The server attempts to contact a DHCP server for an IP address. Once a DHCP
server is contacted, the LCD panel displays the default SP settings. The SP address is
configured and the server is ready for use.
7. Continue with "Creating the Initial Manager Account" on page 14 for instructions
on creating the initial manager account.
Note – A prompt appears that asks if you want to perform autoconfiguration. As an
alternative to configuring an SP manually, you can run autoconfiguration, which
replicates the configuration of one SP to another. See "Autoconfiguring the SP" on
page 14.
Select Forward
Press both for Enter
Chapter 2 Initial Software Configuration 11