Credit Card Reader Board - HP ElitePad 1000 G2 Maintenance And Service Manual

Credit card reader board

NOTE: The credit card reader board spare part kits do not include the respective cables. The cables are
included in the Cable Kit, spare part number 744031-001.
Description
Left-side credit card reader board
Right-side credit card reader board
Before removing the credit card reader boards, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and
then shut it down through the operating system.
2. Disconnect the power from the tablet by unplugging the power cord from the tablet or the Retail Jacket.
3. Disconnect all external devices from the Retail Jacket.
4. Remove the top cap (see
5. If installed, remove the tablet from the Retail Jacket (see
6. Remove the front cover (see
Remove the credit card reader boards:
1. Remove the Phillips PM1.9×3.0 screw (1) that secures the left-side credit card reader board to the rear
cover.
2. Turn the left-side credit card reader board (2) over so the ZIF connector on the back of the board is
accessible.
74 Chapter 5 Removal and replacement procedures
Top cap on page 63).
Front cover on page 65).
Spare part number
744027-001
744028-001
Top cap on page 63).