Fingerprint Reader Board - HP ELITE x2 1012 G1 Maintenance And Service Manual

Fingerprint reader board

Description
Fingerprint reader board (includes cable)
IMPORTANT:
and replacement.
Before removing the display panel, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Keyboard (select products only) (see
b. Back cover (see
c. Display panel (see
d. Touch controller board (see
e. WLAN module (see
f. WWAN module (select products only) (see
g. Solid-state drive (see
h. Battery (see
i. System board (see
Remove the fingerprint reader board:
▲ Remove the fingerprint reader bracket (1), and then remove the fingerprint reader board (2), which is
secured with tape.
54 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
Make special note of each screw and screw lock size and location during removal
Back cover on page
Display panel on page
Touch controller board on page
WLAN module on page
Solid-state drive on page
Battery on page
System board on page
Keyboard (select products only) on page
30)
31)
34)
WWAN module (select products only) on page
38)
42)
50)
Spare part number
844875-001
29)
33)
36)