Set Password - NetComm NP3024 User Manual

Set Password

The Set Password screen allows the network manager to secure the Switch settings. Use this screen
to change the password.
If you forget the password, you can press the "Reset" button in the rear panel of the Switch to
restore the Switch to its factory default settings.
Note: All other settings will also be lost, including VLAN, Port Settings, etc. Refer
to Backup Setting to back up your settings before restoring the Switch to its
factory default.
NetComm 16 or 24 port Gigabit Switch
32
Figure 27. Set Password
YML711 Rev1
www.netcomm.com.au