Setting Power-Up Conditions And Decoder (Set Up 4) - System Configuration Menu; Overview; Structure Of The System Configuration Menu [C4] - Sony Trinitron BVM-20G1U Operation Manual

Setting Power-Up Conditions and Decoder (SET UP 4) —
SYSTEM CONFIGURATION Menu

Overview

The SYSTEM CONFIGURATION menu is used for
the following settings:
• Power-up condition
This menu sets the condition of the monitor when the
MAIN POWER switch on the rear panel is switched
on.
• Power-up input channel
This menu sets the power-up input channel.
• Time from power-up until degauss
If several monitors are turned on at the same time and
all start degaussing at the same time, there will be a
very large current draw on the power supply for a few
moments. To prevent this, the delay time between
power-up and degaussing can be set for each monitor
independently.
Structure of the SYSTEM CONFIGURATION Menu
Main Menu Level 1
SET UP C
INPUT CONFIGURATION [C1]
REMOTE [C2]
PASSWORD [C3]
SYSTEM CONFIGURATION [C4]
ON SCREEN SET [C5]
ALIGNMENT [C6]
EXTEND MENU [C7]
• Residual subcarrier detection (when using the
BKM-24N/25P)
It is possible to detect residual subcarrier signals from
phase change by setting the decoder adpator's
residual subcarrier switch on.
• Auto chroma control (ACC) (when using the BKM-
27T)
• Setting of the contrast and brightness after
adjusting the white balance.
• Assigning shortcut to the menu to the [F2] key
Assigns the shortcut to the MANUAL menu of the
COLOR TEMP ADJ menu to the [F2] key. This
allows you to jump directly to the MANUAL menu
corresponding to the color temperature set to the
currently displayed image (STD/COL 1/COL 2).
[C4]
Level 2
STANDBY MODE
DEFAULT CH
DEGAUSS DELAY
RESIDUAL SC SW
ACC SW
CONT/BRT HOLD
COL TEMP SHORT-CUT
39