Table of Contents
Advertisement
SYSTEM SETTING menu
The SYSTEM SETTING menu is used for setting the
system. You can set the display language and so on.
Items that cannot be adjusted depending on the input
signal are displayed in black.
SYSTEM SETTING 1/2
R G B / C O M P S E L :
C O M P O N E N T L E V E L :
N T S C S E T U P :
S C A N :
G A M M A :
F O R M AT D I S P L AY:
L A N G U A G E :
B A C K G R O U N D :
I / P M O D E :
SYSTEM SETTING 2/2
S D P I X E L M A P P I N G
C O M P O S I T E & Y / C :
R G B / C O M P O N E N T :
Submenu
Setting
RGB/COMP SEL
When a signal input via the RGB/
COMPONENT connector is being
monitored, based on the signal
being input, select RGB or COMP
(component).
COMPONENT LEVEL
Selects the component level from
among three modes.
• SMPTE: for 100/0/100/0 signal
• BETA7.5: for 100/7.5/75/7.5
• BETA0: for 100/0/75/0 signal
NTSC SETUP
Selects the NTSC setup level from
two modes.
The 7.5 setup level is used mainly
in North America. The 0 setup level
is used mainly in Japan.
SCAN
Sets the scan size of the picture.
Select from OFF and FULL.
The display format changes
depending on the mode selected.
(See "Scan mode image" on page
27.)
• OFF: Changes between over scan
• FULL: Changes to over scan,
GAMMA
Select the appropriate gamma
mode. You can select from among
five settings. When "3" is selected,
the setting is roughly same as the
gamma mode of the CRT (2.2).
xxx
xxxxx
x
xxxxxx
xx
xx
E N G L I S H
xx
x
xxxxxxx
xxxxxxx
signal
and normal scan.
normal scan or full screen.
Submenu
FORMAT DISPLAY
LANGUAGE
BACKGROUND
I/P MODE (picture delay
minimum)
26
Setting
Selects the display mode of the
signal format.
• AUTO: The format is displayed
for about 10 seconds when
the input of the signal starts.
• ON: The format is always
displayed.
• OFF: The display is hidden.
Selects the menu or message
language.
Sets the brightness of the black bars
appearing on the sides of the
screen.
• OFF: Displays a darker bar
(black).
• ON: Displays a brighter bar
(gray).
Select to set the delay by the picture
processing to the minimum level
when the signal is input.
• INTER-FIELD: Performs
interpolation depending on
the movement of the images
between the fields. It takes
longer than "LINE
DOUBLER" for processing
the picture. "INTER-
FIELD" is the factory
setting.
• LINE DOUBLER: The
processing time is shorter.
Performs interpolation by
repeating each line in the
data receiving sequence
regardless of the field. As
the line flicker is displayed
in this mode, it is available
for checking the line flicker
of the telop work and so on.
Advertisement
Table of Contents
