Menu; E Setting The Power-Up Conditions And Data About The Screen Display - System Config Menu; Structure Of The System Config Menu; Setting Lists Of The System Config Menu - Sony TRINITRON BVM-D9H1U Maintenance Manual

E Setting the Power-Up Conditions and Data about the Screen Display — SYSTEM CONFIG Menu

Structure of the SYSTEM CONFIG Menu

Level 1 Level 2
SYSTEM CONFIG (1/2)
@ STANDBY MODE
@ DEFAULT CH LAST
@ DEGAUSS DELAY CH x
@ CONT/BRT HOLD
@ COL TEMP SHORT-CUT
@ ACC SW
CONFIG COPY E1 MONITOR ADDRESS E11
@
SYSTEM CONFIG (2/2)
@ FORMAT DISPLAY E2
@ POSITION
@ CH NO E3
@ POSITION
@ CH NAME E4
@ POSITION
@ CAPTION E5
MAINTENANCE ENTER PASSWORD
@

Setting Lists of the SYSTEM CONFIG Menu

This section explains the setting lists displayed in the

menu.

How to read the setting lists
• For purposes of explanation, each setting list is
preceded by a menu number. These numbers are not
displayed on the screen.
For more information about the menu number, see "About
menu numbers" on page 26(E).
• The arrow mark (÷) refers you to another setting list
that appears after you make the setting, or to an
operation that is carried out as a result of the setting.
When there is no arrow mark, the menu does not have
any sub-list.
• The factory setting is shown in the brackets.
40
(E)
[E] (1/2) SYSTEM CONFIG (1/2) menu
Set each of the following items.
STANDBY MODE: Select the power-up condition
when the MAIN POWER switch is turned on
(BVM-D14H1U/D14H1E/D14H1A/D14H5U/
D14H5E/D14H5A) or when the battery is installed
(BVM-D9H1U/D9H1E/D9H1A/D9H5U/D9H5E/
D9H5A.)
ON: Standby mode
[OFF]: Operation mode
DEFAULT CH: Select the power-up input channel
(LAST or CH x).
[LAST]: Set the channel to the channel that was
selected at the time the power was last turned
off.
CH x: Set the channel to a specific channel
number.
DEGAUSS DELAY: Set the time between power-up
and the beginning of degaussing. Enter the desired
time (in seconds, 0 to 255).
CONT/BRT HOLD: Select the contrast and
brightness settings to the center or adjusted value
after adjusting the white balance or auto
adjustment of CONTROL PRESET ADJ (OFF or
ON).
ON: The contrast and brightness are set to the
value before adjusting.
[OFF]: The contrast and brightness are set to the
center value (100) after adjusting.
COL TEMP SHORT-CUT: Assign the shortcut
function to the MANUAL menu of the COLOR
TEMP ADJ menu to [F2] key (OFF or F2).
F2: Assigns the shortcut to the MANUAL menu
of the COLOR TEMP ADJ menu.
[OFF]: Does not assign the shortcut to the
MANUAL menu of the COLOR TEMP ADJ
menu.
ACC SW: Set the automatic color control switch (OFF
or ON).
CONFIG COPY...: Copy setting data of the INPUT
CONFIG and SYSTEM CONFIG (except the
DEGAUSS DELAY data) menus from the serial
connected BVM-D9H/D14H monitor. ÷[E11]
[E11] MONITOR ADDRESS menu
Set the address number of the monitor to be copied.
[E] (2/2) SYSTEM CONFIG (2/2) menu
Select items to be displayed on the screen.
FORMAT DISPLAY: Select the display mode of the
signal format. ÷[E2] (2/2)
POSITION: Select the display position of the
signal format. ÷[E2] (2/2)
CH NO: Select the display mode of the channel
number. ÷[E3] (2/2)
POSITION: Select the display position of the
channel number. ÷[E3] (2/2)
CH NAME: Select the display mode of the channel
name. ÷[E4] (2/2)
POSITION: Select the display position of the
channel name. ÷[E4] (2/2)
CAPTION: Select the caption display mode.
÷[E5] (2/2)
MAINTENANCE...: Menu for service personnel.
[E2] (2/2) FORMAT DISPLAY and POSITION
menus
FORMAT DISPLAY menu
Select the display mode of the signal format.
[AUTO]: Disappears after displayed for a while.
ON: Displayed.
OFF: Not displayed.
POSITION menu
Select the display position.
[BOTTOM LEFT]
BOTTOM CENTER
BOTTOM RIGHT
TOP LEFT
TOP CENTER
TOP RIGHT
[E3] (2/2) CH NO and POSITION menus
CH NO menu
Select the display mode of the channel number.
[AUTO]: Disappears after displayed for a while.
ON: Displayed.
OFF: Not displayed.
POSITION menu
Select the display position.
BOTTOM LEFT
BOTTOM CENTER
[BOTTOM RIGHT]
TOP LEFT
TOP CENTER
TOP RIGHT
[E4] (2/2) CH NAME and POSITION menus
CH NAME menu
Select the display mode of the channel name.
[AUTO]: Disappears after displayed for a while.
ON: Displayed.
OFF: Not displayed.
POSITION menu
Select the display position.
BOTTOM LEFT
BOTTOM CENTER
BOTTOM RIGHT
[TOP LEFT]
TOP CENTER
TOP RIGHT
[E5] (2/2) CAPTION menu
Select the caption display mode.
[OFF]: Not displayed
CAPTION 1: Displayed in CAPTION 1 mode.
CAPTION 2: Displayed in CAPTION 2 mode.
TEXT 1: Displayed in TEXT 1 mode.
TEXT 2: Displayed in TEXT 2 mode.
41
(E)