To Unweb The Laminator; Clearing A Film Jam - GBC TALON 44 Operation And Maintenance Manual

Cut web
Fig. 33
Pull web
Fig. 34
48
Cut web
Cut web

TO UNWEB THE LAMINATOR

Unweb the laminator if you are
changing film widths, cleaning the
rollers or have finished using the
machine for the day.
1. Using the rear slitter, cut the
output from the web (Figure 33).
2. Set the roller handle to the
"Release" position.
3. Remove the safety shield and tilt
the feed table.
4. Cut remaining top and bottom film
webs between supply rolls and
heat rollers (Figure 33). Be
careful not to cut any of the
rollers!
5. Carefully grab hold of the web
(top and bottom film), from the
front operating position and pull
towards you (Figure 34).
6. Do not allow the adhesive side
of the film to contact the heat or
pull rollers.
CLEARING A FILM JAM (Wrap-
up)
Film jams (wrap-ups) may occur if
the film is loaded backwards or if
the area at which film exits the
equipment is blocked. The film,
when jammed, wraps around the
heat rollers during webbing if a
threading card is not used or pull
rollers during operation.
To clear a jam:
1. Immediately stop the laminator by
pressing STOP ( ).
2. Remove the safety shield and tilt
the feed table.
3. Press and hold REVERSE (
until the jam has cleared the heat
rollers or pull rollers
4. Set the roller handle to the
"Release" position.
5. Manually assist the material
through the main rollers and/ or
pull rollers.
6. Once the jam has been cleared,
set the roller handle to one of
the laminating positions.
7. You can now resume laminating.
I
)