Installation - GBC TALON 44 Operation And Maintenance Manual

Fig. 4
20

INSTALLATION

1. Shipping damage should be
brought to the immediate
attention of the delivering
carrier.
2. With assistance, carefully roll
the laminator into position over
flat and even surfaces.
3. The laminator should be
positioned to allow exiting film to
flow freely to the floor or a work
table (Figure 4). Accumulation of
laminate immediately behind the
laminator as it exits the equip-
ment may cause the film to wrap
around the pull rollers, resulting
in a "jammed" condition.
4. Avoid locating the laminator near
sources of heat or cold. Avoid
locating the laminator in the
direct path of forced, heated or
cooled air.
5. Once the laminator has been
properly positioned, lock the
castors in place. Locking the
castors prevent the machine
from rolling during set up,
operation or servicing.
6. The heaters must be installed by
a GBC qualified service
technician. Refer to your
Warranty section for explanation
of "Qualified".
7. Connect the attachment plug
provided with the laminator to a
suitably grounded outlet. Avoid
connecting other equipment
to the same branch circuit to
which the laminator is
connected, as this may
result in nuisance tripping
of circuit breakers or
blowing fuses.
I