Loading Bottom Psa Film; Loading Bottom Mount Adhesive - GBC TALON 44 Operation And Maintenance Manual

Fig. 26
Fig. 27
40

LOADING BOTTOM PSA FILM

This procedure describes how to
load a roll of mount adhesive using
the lower unwind position for
decaling (Figure 26).
1. At this point you should have an
upper roll of PSA film loaded
onto the laminator.
2. Ensure no brake tension is
applied to the film shaft.
3. Pull the lower roll of film around
the lower idler bar and towards
the lower rewind.
4. Place one piece of masking tape
in the center of the film and
secure to the rewind tube.
5. Make two full wraps around the
rewind tube, then carefully
score the laminate without
cutting the release liner.
6. Adhere the lower PSA film to the
loaded upper roll of film by
pulling the film straight up
towards the main rollers.
7. Reference THREADING CARD
PROCEDURE next.
LOADING BOTTOM MOUNT
ADHESIVE
This procedure describes how to
load a roll of mount adhesive using
the lower unwind position for
decaling (Figure 27).
1. At this point you should have an
upper roll of film loaded onto the
laminator.
2. Ensure no brake tension is
applied to the film shaft.
3. Adhere the mount adhesive to
the loaded upper roll of film by
pulling the mount adhesive
straight up towards the main
rollers. Do not web around the
lower idler.
4. Reference THREADING CARD
PROCEDURE next.
I