To Unweb The Laminator; Clearing A Film Jam (Wrap-Up) - GBC 2064WF-1 Installation And Operating Manual

GBC 2064WF-1

To unweb the laminator

Unweb the laminator if you are changing film
widths, cleaning the rollers or have finished using
the machine for the day.
CAUTION: Do not cut yourself
1. Using a slitter, cut (1) the output from the web
(Fig. 28).
2. Cut (2) remaining top film web between the
idler bar and heat roller. PSA film cut the
release liner too.
3. Cut (3) the film web between the lower film
supply and the idler bar (Fig. 28).
CAUTION: Be careful not to cut any of the
rollers!
4. Remove the feed table.
5. Gap the main rollers and pull rollers.
6. Carefully grab hold of the web (top and bottom
film), from the back operating position and pull
towards you (Fig. 29).
7. Do not allow the adhesive side of the film to
contact the heat or pull rollers.

Clearing a Film Jam (Wrap-up)

Film jams (wrap-ups) may occur if the film is loaded
backwards or if the area at which film exits the
equipment is blocked. The film, when jammed,
wraps around the heat rollers or pulls rollers during
webbing if webbing, if a Thread Card is not used.
To clear a jam:
1. Immediately stop the laminator by pressing
STOP ( ).
2. Set motor direction to rear.
3. Use the footswitch to reverse the web until the
wrap up is clear.
4. Raise the main roller and pull rollers.
5. Manually guide the web from the main rollers
and pull rollers.
6. Once the film jam has been cleared, lower the
main roller and pull rollers.
7. Refer to the section
LAMINATING.
© 2009 General Binding Corporation an ACCO Brands CO.
.......a PSA film or mount adhesive
titled START
(2)
(3)
(2)
FIGURE 28
FIGURE 29
Operation Manual
(1)
PULL WEB
Page 22