Upper Rewinder Direction Switch; Lower Rewinder Direction Switch; Rear Control Switch; Foot Sw Enable - GBC TALON 44 Operation And Maintenance Manual

Hide thumbs Also See for TALON 44:
Table of Contents

Advertisement

FWD.
REV.
REV.
FWD.
Fig. 10
"REVERSE"
Fig. 11
TOP
032
o
F
SPEED
03
BOT
032
o
F
JOB
01
Release

Foot SW Enable

Fig. 12
26
E. UPPER REWINDER DIRECTION
SWITCH: (Figure 10) This switch
enables the operator to control the
REWINDER
direction of the upper rewind/
FWD.
unwind shafts.
STOP
"FWD." : In this position, the motor
REV.
runs in a forward direction.
"STOP" : Stops the rewinder motor
(E) (F)
for the rewind/ unwind shaft
selected.
"REV." : In this position, the motor
runs in a reverse direction.
F. LOWER REWINDER DIRECTION
REV.
SWITCH: (Figure 10) This switch
enables the operator to control the
direction of the Lower rewind/
FWD.
unwind shaft.
"FWD." : In this position, the motor
runs in a forward direction.
"STOP" : Stops the rewinder motor
for the rewind/ unwind shaft
selected.
"REV." : In this position, the motor
runs in a reverse direction.
G. REAR CONTROL SWITCH:
(Figure 11) This switch enables the
operator to run jobs from the rear
operating position of the laminator
"RUN"
when rear controls are enabled.
"REVERSE" : In this position, the
rollers turn from the front operating
position towards the rear operating
position.
"STOP" : Stops the movement of
the rollers.
"RUN" : In this position, the rollers
turn from the rear operating position
towards the front operating position.
(G)
ENABLE REAR CONTROL SWITCH:
To enable the rear control switch,
press and hold JOB
hear a beep, approximately 3
seconds. REAR CONTROL
replaces READY/ WAIT on the
control panel display.
Replace the rear slitter with the
safety shield properly installed and
latched.
DISABLE REAR CONTROL SWITCH:
Press and hold JOB
disable the rear control switch.
H. FOOT SW ENABLE: (Figure 12)
In this mode permits operation using
the footswitch.
To enable the foot switch, press
and hold STOP
beep, approximately 3 seconds.
FOOT SW ENABLE flashes where
READY/ WAIT is indicated.
(H)
Press and hold STOP
disable the foot switch.
until you
again to
until you hear a
again to
I

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Talon 64

Table of Contents