Features Guide; Power Switch; Control Panel Indicators; Control Panel Buttons - GBC Falcon 60+ Operation Manual

Operations Manual
O
(1)
(2)
(3)
(4)
5 6
4 7
3 8
2 9
1 10
©2004 General Binding Corporation
Fig 5
Fig 6
O C
READY
O F
TOP TEMP
O C
READY
O
F
BOTTOM
TEMP
Fig 7
FALCON

Features Guide

A. POWER ON/ OFF: (Figure 5) Located at the back left
of the machine applies power to the laminator. The control
panel will illuminate when the switch is rotated to the "l"
position. The off position, marked "O", removes power
from the laminator.
B. CONTROL PANEL INDICATORS: (Figure 6)
1. POWER INDICATOR
nator is plugged in and POWER ON/ OFF is in the
on, (I), position.
2. PRESSURE INDICATOR
to correspond with the amount of pressure at the main
roller nip. Pressure is represented by percent from 0
(minimal) to 100 (maximum).
3. READY INDICATOR: "READY" Illuminates when the
actual temperature is equal to (+/- 5) set tempera-
ture.
4. °C INDICATOR: "°C" Illuminates indicating the
displayed value is in degrees Celsius.
5. °F INDICATOR: "°F" Illuminates indicating the displayed
value is in degrees Fahrenheit.
6. ON INDICATORS : Located near the heater and
cooling fan on buttons. Illuminates when the related
on button is pressed.
7. SELECTION INDICATORS
stop and forward/ reverse buttons. Illuminates when
the selected button is pressed.
C. CONTROL PANEL BUTTONS: (Figure 7)
1. START : When pressed, indicator illuminates and
activates rollers for normal operation.
2. STOP : When pressed, indicator illuminates and
stops the movement of the rollers.
3. REVERSE : When pressed, indicator illuminates and
sets the motor direction for reverse roller movement
to clear film jams and wrap-ups.
4. FORWARD : When pressed, indicator illuminates and
sets the motor direction for forward roller movement
to run in normal operation mode.
60+ (-1)
CE
:Illuminates when the lami-
: Illuminates in increments
: Located near the start/
Page 17