Assembly - Pro-Form crosswalk 395 User Manual

ASSEMBLY
- Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials, Do not dispose of the packing
materials until you finish assembly,
• The underside ofthe walkingbelt is coated with
high-performancelubricant. After shipping, there
may be some lubricanton top of the walking belt
or on the shipping carton. This is normal. Jfthere
is lubrica._t o n top of the walking belt, wipe itoff
with a softcloth and a mild, non-abrasive cleaner.
- TOidentify small pans. see page 6.
• Assembly requiresthe following tools:
the includedhex keys I_=
one Phillipsscrewdriver
SCissors _===;z_
• To avoid damaging parts, do not use power tools,
1. Make sure that the power cord Is unplugged.
Remove and discard the two screws (A) and the
shipping bracket (B) from the rightside of the
Base (74). Then, remove and discardthe screws
and shippingbracket (not shown) from the [eft
side ofthe Base.
74
2. With the help of a second person, tip the tread- 2
mill onto its left side. Partially pivot the Base (74)
to hetp stablize the treadmill.
Pull the Upright Wire (63) and the ground wire
through the indicated hole in the Base (74).
Attach the ground wire to the Base (74) with a #8
x 1/2" Ground Screw (t).
See the inset drawing, Cut the plaslic tie near
the Upright Wire (63). Be careful not to dam-
age the Upright Wire.
63
.Ground Wire