Pro-Form crosswalk 395 User Manual page 12

11. Identify the Left and Right Upper Body Arms (84,
85),
Make sure that the Left Upper Body Arm (84)
is positioned as shown. Attach the Left Upper
Body Arm to the Left Upright (66) w;'th two U4" ×
3 1/2" Screws (56), two 1/4" Star Washers (23),
and two 3/8" Star Washers (3) as shown, Do not
overtighten the Screws,
Attach the Right Upper Body Arm (85) as de-
scribed above.
12, Attach the Latch Housing (67)with the Latch
Spacer (82) to the Left Upright (66) with two #10
x 1 112" Screws (8); make sure that the large
hole in the Latch Housing is on the indicated
side. Start both Screws, end then tighten
them, Be careful not to overtighten the
Screws.
Locate the Latch Pin Assembly (68). Remove the
knob from the pin. Make sure that the collar and
the spring are on the pin, (Note: If there are two
collars, place one on each side of the spring,)
Insert the pin into the Latch Housing (67), Then,
tighten the knob onto the pin,
12
13. Make sure that all parts are properly tightened before you use the treadmill, If there are sheets of plas-
tic on the treadmill decals, remove the plastic, To protect the f_oor or carpet, place a mat under the treadmill.
Note: Extra hardware may be included, Keep the included hex keys in a secure place; one of the hex keys is
used to adjust the walking belt (see pages 21 and 22).
12