Pro-Form crosswalk 395 User Manual page 9

Hold the
R ight Upright (76) against the Base
(74). Re careful not to pinch the wires.
Partially tighten three 3/8" x 3 114" Screws (2)
w_th three 3/8" Star Washers (3) into the Right
Upright and the Base; do not fully tighten the
Screws yet.
With the help of a second person, tip the
treadmill onto its right side. Press in a Base
Cap (not shown) and attach the Left Upright
(not shown) as described in steps 3 and 5.
Note: There are no wires on the left side.
Identify the Left andRight Handrails (59, 64),
which are marked "Left" and "Right," Remove the
four 5/16"x 314" Screws (5) and four 5/16 =Star
Washers (8) from the bottoms and sides of each
Handrail,
Held the Right Handrail (64) near the Right
Upright (76). Insert the wire tie on the Upright
Wire (63) through the hole in the bottom and
out ot the hole in the side of the Left Handrail as
shown, Then, pullthe Upright Wire throughthe
Right Handrail ......................
Attach the Right Handrail (64) tOthe Right
Upright (76) with two of the 5/I6" x 3/4" Screws
(5) and two of the 3/'8"Star Washers (6) that
you jUSt removed,Make sure not to pinch the
Upright Wire (63), Start both Screws, and
then tighten them,
Attach the Left Handrail (59) to the Left UpTight
(66) as described above. Note: There are no
wires on the left side.