Pro-Form crosswalk 395 User Manual page 21

Locate the Reed Switch (33) and the Magnet (32)
on the right side of the Pulley (31). Turn the Pulley
until the Magnet is aligned with the Reed Switch.
Make sure that the gap between the Magnet
and the Reed Switch is about 1/8 in. (3 ram).
If necessary, loosen the #8 x 314" Truss Head
Screw (t4), move the Reed Switch slightly, and
then retighten the Screw. Carefully slide the Motor
Hood (not shown) back on bytining up the guides,
Reattach the Motor Hood with the five #8 x 3/4"
Screws (not shown). Then, plug in the power cord,
insert the key, and run the treadmill for a few min-
utes to check for a correct speed reading.
V,ew
®
SYMPTOM: The incline of the treadmill does not
change correctly
Hold down the Stop button and the Speed increase
button, insert the key into the console, and then
release the Stop button and the Speed increase
button. Press the Stop button and then press the
Incline increase or decrease button. The treadmill
will automatically rise to the maximum incline level
and then return to the minimum level This will re-
calibrate the incline system. If the incline does not
begin calibrating, press the Stop button again, and
then press the Incline increase or decrease button
again. When the incline is calibrated, remove the
key from the console.
SYMPTOM: The walking belt slows when walked on
a. Use only a single-outletsurge suppressorthat
meets all ofthe speallicaiians described on
page 13.
if the walking belt is overtightened, treadmill per-
formance may decrease and the walking belt may
become damaged, Remove the key and UNPLUG
THE POWER CORD. Usingthe hex key, turn both
id[erroller screws counterclockwise,1t4 of a turn.
When the walking belt is properlytightened, you
should be able 1olift each edge of the walking belt
2 to 3 in, (5 to 7 cm) offthe walking platlorm, Be
carefulto keep the walkingbelt centered, Then,
plugin the power cord, insertthe key, and run the
treadmill for a few minutes.Repeat untilthe walk-
ing belt is properly tightened.
Idler Roller Screws
c. Your treadmill feaiures a walking belt coated with
high-performance lubricant. IMPORTANT: Never
apply silicone spray or other substances to the
walking belt or the walking platform unless in-
structed to do so by an authorized service rep-
resentative. Such substances may deteriorate
the walking belt and cause excessive wear, If
you suspect that the walking belt needs more lubri-
cant, see the front cover el this manual.
d. If the walking belt still slowswhen walked on, see
the front cover of this manual.
21