Error Messages - Avery Dennison ADTP-1 Operator's Handbook Manual

E r r o r M e s s a g e s
Contact your System Administrator if you cannot clear an error
or you see an error not listed below.
Many of these errors require action by your System
Administrator.
Error Action
411 Make sure the printer's communication values match those at the host.
614 Check for invalid characters in the data packets.
616 A bar code on the label did not print. Check with your System Administrator.
703 Check/load supply. The printer's supply type must match the loaded supply.
704 For example, the printer is set for die cut supply, but black mark supply is
loaded.
741 Check supply loading and the settings in the Monarch® RFID Printer Setup
743 Utility.
750 Turn off the printer to let the printhead cool down.
751 Load supply.
Press ENTER to continue printing.
752
753
Clean sensor.
756
757
754 Check/load ribbon. Press ENTER to continue printing.
755 Close the printhead to continue.
758 Check for a label jam, clear the supply path, or reload supplies. This error
may occur if you remove a label too quickly in the on-demand mode.
763 Waiting to dispense label. Press FEED.
765 Check/replace the printhead. Press ESCAPE to continue.
768
Remove the liner from the take-up core. Reload supply for liner take-up.
785
Press ESCAPE to continue.
786
Note: If the above actions do not clear the error, turn off the printer, wait several
seconds and then turn on the printer.
6-4 Operator's Handbook
ERROR #756
Load supplies
ENTER ESCAPE