Error Codes; Technical Support - Avery Dennison Monarch Operator's Handbook Manual

Error Codes

This section lists common error codes and what they mean.
Code(s) Description
004 - 005 Supply size is incorrect. Reload the correct supplies.
267 – 271
Communication error. See your System Administrator.
410 - 413
703 - 704 Supply Error. Load supplies or make sure they are loaded correctly. See "Loading
Supplies" in Chapter 3 for more information.
750 Printhead is overheated. Turn off the printer to let it cool.
751 - 753 The printer sensed a problem with a mark on the supplies. Check the supplies to see if
they are loaded correctly.
756 The printer is out of supplies. Load supplies. See "Loading Supplies" in Chapter 3 for
more information.
757 The calibrated supply length differs by plus or minus .25 inches from the format. Load
supplies.
Check supply. Either the supply is not seen, or the on-demand sensor is broken
758
(purchase optional). Check for a label jam. Clear the supply path or reload supplies.
The printer does not recalibrate after this error.
762 Low battery. Recharge the battery. See "Charging the Main Battery" in Chapter 2 for
more information.
763 Waiting to dispense label. Press Enter.
768 Printhead error. See your System Administrator.
790 - 791 The printer is busy or has an error pending. Turn off the printer, wait two seconds, and
then turn it back on.
904 – 911 System error. See your System Administrator.
SYSTEM System error. See your System Administrator.
ERROR
VECTOR ##
T e c h n i c a l S u p p o r t
If these solutions do not work or you have a problem or error code not listed, see your System
Administrator or call Service at the number listed on the back of this manual.
Troubleshooting 6-3