NEC 1080Xd User Manual page 185

1. Check that the front stabilizer is in the pulled-out position. If not, remove the
screw securing the stabilizer and pull it out (see Figure 5-10).
2. Remove the front bezel from the front of the PCIX unit by pulling it first
from the bottom and then away from the top of the unit (see Figure 5-10).
A
B
Figure 5-10. Stabilizer and PCIX Unit Front Bezel
3. Remove the two screws (one on each side) securing the PCIX unit to the
front of the cabinet (see Figure 5-11).
Figure 5-11. PCIX Unit Screws
B
A
Stabilizer
PCIX Unit Front Bezel
A
A Server Screws (2)
I/O Board Installation 5-13