NEC 1080Xd User Manual page 30

Setting Up the Server
Use the following procedure to set up the server.
Note:
familiar with server features, such as the location of system
switches, indicators, and main chassis components.
1. Check that the server has been installed as described in the
Express5800/1080Xd/1160Xd/1320Xd Site Preparation Guide and
Express5800/1080Xd Installation Procedures. This server requires
installation by qualified personnel such as an NEC technician and system
administrator.
2. Make sure that any optional components other than I/O cards or boards,
have been installed by an NEC technician.
If you have an I/O card or board to install, install it now (see Chapter 5, "I/O
Board Installation").
3. Unlock the rear door of the server with the security key. Open the door by
lifting the handle and turning it clockwise (see Figure 2-1).
Server cable connectors for system setup are located at the rear of the server.
2-2 System Operation
See Chapter 1 of this user's guide to become
A Lift Handle
B Turn Clockwise
Figure 2-1. Opening the Rear Server Door
B
A