Honeywell HISD-1181W Operation Manual page 38

Operating Guide for IP Camera
•
Alarm output: Enable or disable linkage alarm output.
•
Alarm output duration: Set the duration of the linkage alarm output after being
triggered (in seconds), the range of the duration is 0~86400s.0 means that there is no
limit for alarm output.
•
E-mail: Send sensor alarm information to users via E-mail, details about E-mail setting
please refer to [Network Settings].
•
Snap: When alarm is triggered, the device SD card will be driven to snap pictures. The
pictures can be saved via E-mail sending or FTP uploading. For snapping parameters, if
the number of pictures snapped at one time is set as 10, and the snapping interval is 1
second, that means when there is an alarm, 10 pictures will be snapped and the interval
between each picture is 1 second.
•
Record: When alarm is triggered, the device SD card will be driven to record images.
The record files can be saved via E-mail sending or FTP uploading.
After setting all the parameters, click Save to make the parameters valid.
Failure Setting
See Figure 3-38 for the interface of "Failure Setting":
Set network failure alarm parameters here: detection on/off, linkage alarm, alarm output
duration, E-mail sending when alarm has been triggered, linkage snapping/recording, etc.
•
Enable detect: Enable or disable network failure alarm detection.
•
Alarm output: Enable or disable linkage alarm output.
32
Record file packet time equals duration of alarm add the record
time set in Linkage recording.
Figure 3-38