Honeywell HISD-1181W Operation Manual page 27

Auto-mapping of port, when IP camera is connected to a router with UPNP function enabled,
the router will automatically map the port in UPNP settings to public network, manual port
mapping by users is not necessary.
•
Network card: select the type of NIC connecting UPNP router. For WiFi models,
when IP camera is connected to router via WiFi network, select "wireless" mode.
•
Mode: Designate mode and auto mode.
Designate mode means to specify data mapping port and web mapping port to
router.
Auto mode means data mapping port and web mapping port are set up by router.
•
Server URL: IP address of the router with UPNP.
•
Data port map No.: Data mapping port of user-specified device on the router
(works only under specified mode).
•
Web port map No.: Web mapping port of user-specified device on the router
(works only under specified mode).
•
Data mapping status: When UPNP function runs successfully, the status bar will
echo the data port mapped to the router by the device.
•
Web mapping status: When UPNP function runs successfully, the status bar will
echo the web port mapped to the router by the device.
After you set these parameters, please click Save to make them valid.
EMail
See Figure 3-26 for the interface of "EMail setting":
To set the mailbox addresses and parameters of alarm mails and public network IP mails.
•
SMTP server: The address of servers that send the mails, the address format of
mail servers varies from provider to provider, e.g. the SMTP server of 163 mailbox
is smtp.163.com.
Figure 3-26
Honeywell
21