Operating Guide for IP Camera
In this page, users can set features like motion detection on/off, sensitivity, detection time,
linkage alarm output, alarm output duration, E-mail sending when alarm been triggered,
linkage snapping/recording, etc.
•
Enable detect: Enable or disable motion detection.
•
Sensitivity: Sensitivity range is 1~5, greater value means higher sensitivity.
•
Deployment Time: Set the period of time for motion detection, two periods
allowed.
•
Alarm output: Enable or disable linkage alarm output.
•
Alarm Output duration: Set the duration of the linkage alarm output after being
triggered (in seconds), the range of the duration is 0~86400s.0 means that there is
no limit for alarm output.
•
E-mail: Send motion detection alarm information to users via E-mail, details about
E-mail setting please refer to Network Settings.
•
Linkage Snapping: When alarm is triggered, the device SD card will be driven to
snap pictures. The pictures can be saved via E-mail sending or FTP uploading.
For snapping parameters, if the number of pictures snapped at one time is set as
10, and the snapping interval is 1 second, that means when there is an alarm, 10
pictures will be snapped and the interval between each picture is 1 second.
30
Figure 3-36