Section.5:.Servo.installation - Hangar 9 PULSE XT 40 ARF Assembly Manual

Section 5: Servo Installation
Required Parts
•.Fuselage
3
•.23 / ".(594mm).rudder.pushrod
.
8
1
•.22 / ".(572mm).elevator.pushrod.wire
.
2
•.Clevis.w/retainer
Required Tools and Adhesives
•.Drill.
•.Switch.harness.
•.Phillips.screwdriver
•.Drill.bit:.1/16".(1.5mm),.5/64".(2mm)
Note:.The.throttle.servo.is.not.required.when.
building.the.electric.version.of.your.Pulse.XT.
 
.Step 1
.
If.you.choose.to.use.a.glow.engine,.place.the.throttle.
servo.into.the.fuselage..Use.a.felt-tipped.pen.to.mark..
the.locations.for.the.four.servo.mounting.screws.on..
the.radio.tray.
20
•.Felt-tipped.pen
•.Standard.servo.(3)
 
. .Step 2
Use.a.1/16".(1.5mm).drill.bit.to.drill.the.locations.for.the.
screws..Place.a.drop.of.thin.CA.into.each.of.the.holes.to.
harden.the.surrounding.wood.
 
. .Step 3
Secure.the.throttle.servo.using.the.hardware.supplied.with.
the.servo..Don't.forget.to.install.the.grommets.and.brass.
eyelets.before.installing.the.servo.