Hangar 9 PULSE XT 40 ARF Assembly Manual page 11

 
. .Step 13
Secure.the.servo.using.the.screws.provided.with..
the.servo.
 
. .Step 14
Slide.a.clevis.retainer.onto.a.clevis..Thread.the.clevis..
onto.the.4".(102mm).aileron.pushrod.wire.
 
. .Step 15
Enlarge.the.outer.hole.of.the.servo.arm.using.a.5/64".
(2mm).drill.bit..Attach.the."Z".bend.to.the.servo.arm.
Section 1: Aileron Installation
Note:.You.may.want.to.use.tape.at.the.
wing.tip.and.wing.root.to.hold.the.aileron.
in.position.for.the.next.few.steps.
 
. .Step 16
Plug.the.aileron.servo.into.the.radio.system..With.the.
radio.on,.center.the.aileron.stick.and.trim..Position.the.
aileron.servo.arm.parallel.to.the.hinge.line..Thread.the.
clevis.so.the.pin.in.the.clevis.is.aligned.with.the.trailing.
edge.of.the.wing.
 
. .Step 17
Remove.the.backplate.from.a.control.horn.using.a.hobby.
knife..Attach.the.clevis.to.the.center.hole.of.the.control.
horn..Use.a.felt-tipped.pen.to.mark.the.locations.on.the.
aileron.for.the.three.aileron.control.horn.screws.
11