Hangar 9 PULSE XT 40 ARF Assembly Manual page 14

Section 2: Hinging the Stabilizer

.Step 6
Drill.a.1/16".(1.5mm).hole.in.the.center.of.each.hinge.slot.
in.both.the.elevators.and.stabilizer..Prepare.six.CA.hinges.
by.placing.a.T-pin.in.the.center.of.each.hinge..Slide.the.
hinges.into.the.elevators.until.the.T-pins.are.resting.on.the.
leading.edge.of.the.elevator.

.Step 7
Slide.the.elevators.onto.the.stabilizer..Remove.the.T-pins.
and.use.thin.CA.to.glue.the.hinges..Allow.the.CA.to.fully.
cure.before.testing.and.breaking.in.the.hinges.using.the.
same.technique.as.the.aileron.hinges.
14

.Step 8
Since.the.holes.are.pre-drilled.in.the.elevator,.go..
ahead.and.install.the.control.horn.using.three..
2mm.x.12mm.screws.