Hangar 9 PULSE XT 40 ARF Assembly Manual page 30

Section 7B: Two-Stroke Engine Installation

.Step 4
Mount.the.engine.to.the.mount.using.four.6-32.x.1
screws,.four.#6.washers.and.four.6-32.locknuts.

.Step 5
Slide.a.clevis.retainer.onto.a.clevis,.and.then.thread.the.
clevis.onto.the.throttle.pushrod..Slide.the.pushrod.into.the.
pushrod.tube.and.attach.the.clevis.to.the.carburetor.arm.

.Step 6
Attach.the.pushrod.connector.to.the.throttle.servo.arm.
using.the.connector.backplate..You.will.need.to.enlarge.
the.hole.in.the.servo.arm.using.a.5/64".(2mm).drill.bit.
30

.Step 7
1
/ ". Turn.on.the.radio.system.and.center.the.throttle.stick.and.
.
4
trim..Slide.the.pushrod.into.the.brass.connector..Place.the.
servo.horn.onto.the.servo.so.the.horn.is.perpendicular.to.
the.servo.centerline.

.Step 8
Use.the.radio.to.move.the.throttle.to.the.low.setting..
using.the.stick.and.trim..Move.the.pushrod.so.the.
carburetor.is.closed..Secure.the.pushrod.wire.using.a.
3mm.x.5mm.screw.

.Step 9
Check.that.the.throttle.operates.from.the.radio.without.
binding.at.low.and.high.throttle..Use.the.ATV.setting..
of.the.radio.or.change.the.position.of.the.clevis.at.the.
carburetor.or.the.pushrod.connector.at.the.servo.to.
eliminate.any.binding.