Hangar 9 PULSE XT 40 ARF Assembly Manual page 21


.Step 4
Repeat.Steps.1.through.3.to.install.the.rudder.and..
elevator.servos.

.Step 5
Install.the.switch.harness.on.the.side.of.the.fuselage.using.
the.switch.harness.hardware.

.Step 6
Wrap.the.receiver.and.receiver.battery.in.1/4".(6mm)..
foam.to.protect.them.from.engine.vibrations.
Section 5: Servo Installation

.Step 7
Plug.the.servos,.extensions.and.switch.harness.into.the.
receiver..Plug.the.receiver.battery.and.switch.harness.
together..Place.the.receiver.and.receiver.battery.into.the.
fuselage.

.Step 8
Route.the.receiver.antenna.to.the.rear.of.the.fuselage.
using.the.pre-installed.antenna.tube.
Note:.Do.not.cut.the.excess.antenna.wire.as.
it.will.reduce.the.range.of.your.radio.system.
21