Required Tools And Adhesives; Servo Selection - Hangar 9 FuntanaX 100 ARF Assembly Manual

Required Tools and Adhesives

Tools
• Canopy scissors
• Flat blade screwdriver
• Hobby knife
• Paper towels
• Phillips screwdriver (large)
• Pliers
• Sandpaper
• Square
• Felt-tipped pen
• Drill bits: 1/16" (1.5mm), 3/32" (2.5mm), 1/8"
(3mm), 5/32" (4mm), 11/64" (4.5mm)
Adhesives
• 6-Minute Epoxy (HAN8000)
• Thin CA (PAAPT07)
• CA Remover/Debonder (PAAPT16)
• CA Remover/Debonder (PAAPT16)
Other Required Items
• Epoxy Brushes (DUB345)
• Mixing Sticks for Epoxy (DUB346)
• Rubbing alcohol
• Wax paper

Servo Selection

The servos used for the control surfaces of the FuntanaX 100 must have a minimum of 50 ounce inch of servo torque. We
used JR811 servos in the prototype Funtana.
JR811 Advanced Sport Digital Servo
Torque: 54 oz/in
Weight: 1.44 oz
Motor: Coreless
For optimum performance, we recommend the JR9411 Precision Digital Servos.
JR9411 Premium Digital Servo
Torque: 82 oz/in
Weight: 1.36 oz
Motor: Coreless
6
Speed: .18 sec/60°
Size: 0.75" x 1.49" x 1.52"
Ball Bearing: Dual
Speed: .15 sec/60°
Size: 0.71" x 1.41" x 1.03"
Ball Bearing: Dual
• Drill
• Foam: 1/2"
• Masking tape
• Petroleum jelly
• Phillips screwdriver (small)
• Rubbing alcohol
• Soldering iron
• T-pins
• 30-Minute Epoxy (HAN8002)
• Medium CA (PAAPT01)
• Masking Tape (MMM20901)
• Canopy glue (Formula 560)
• File
• Paper towels
• Ruler