Rc Functions Of The Helicopter - Carson Airbeast 507013 Instruction Manual

b. RC functions of the helicopter
The following functions are controlled
with the two remote control levers of the
portable transmitter.
For every control function there is a trim slider on the remote
control transmitter which permits minor corrections of the
neutral position.
Pitch function
(ascend / descend)
The pitch function controls the flying height of this model
helicopter over a common variation in speed of the two rotors.
The control takes place with the left control lever. To do this,
move it forwards and backwards in a continuously variable
fashion. Contrary to the other control functions this lever does
not spring back into the middle position. If the control lever is
totally drawn towards the back, then the motors are off and the
rotors stand still. If the control lever is pushed forward then the
motor starts running and the rotors run with increasing speed
depending on the lever position.
In the middle position of the control lever, the helicopter should
hover at a fixed height.
Tail function
(Rudder function)
The tail function causes a rotation of the model around the
vertical axis. Since the helicopter has two opposed rotors, no
torque ensues around the vertical axis at the same speed of
the rotors (rotor shaft). The helicopter also therefore requires
no tail rotor for stabilization. In order for the model to be able to
rotate around the vertical axis (rotor shaft), the rotors must run
at slightly different speeds. The resulting torque introduces the
rotation.
At less speed of the steering rotor compared to the bearing
rotor, the torque of the bearing rotor is greater, the helicopter
turns around the vertical axis in the direction of rotation of the
steering rotor. At higher speed of the steering rotor, the torque
of the bearing rotor is less than that of the steering rotor and
the helicopter turns in the direction of the bearing rotor.
The tail function is controlled with the right control lever. If the
lever is moved to the left, the tip of the fuselage turns to the
left. If you move the lever to the right, the tip of the fuselage
likewise turns to the right.
Technical data
Length
Principal rotor diameter
Weight
Battery charger „Lipo Balance II"
Input:
Output:
011640_anl_507013_airbeast_6k.in9 9 011640_anl_507013_airbeast_6k.in9 9
360 mm
340 mm
225 g
100-240 V / AC, 50-60 Hz
7.4 V und 11.1 V/ 0.8A
CARSON Helicopter Airbeast 507013
Roll function
(Aileron function)
The roll function causes the lateral flight of the helicopter by the
lateral lifting and dropping of the wobble plate.
The control takes place with the right control lever.
If the lever is moved to the left, then the model hovers laterally
to the left. Moving the lever to the right makes the model move
laterally to the right.
Nick function
(Elevator function)
The nick function causes forwards and backwards flight of
the helicopter by raising and lowering the wobble plate. The
lower rotor rotation tips slightly downwards and the model tilts
around the transverse axis. When the nose drops downwards, a
part of the lift is transferred into forwards thrust.
If conversely the nose is raised, then the model flies backward.
the control takes place with the right control lever.
Press the lever forward to introduce forwards flight, pull back to
have the model fly backwards.
GB
9
08.01.2008 11:38:15 Uhr 08.01.2008 11:38:15 Uhr