Rc Functions Of The Helicopter; Technical Data; Package Content / Spare Parts - Carson APACHE 2CH Instruction Manual

RC functions of the helicopter

The following functions are controlled with the two remote
control levers of the portable transmitter.
For every control function there is a trim slider on the remote
control transmitter which permits minor corrections of the
neutral position.
Pitch function
(ascend / descend)
The pitch function controls the À ying height of this model helicopter
over a common variation in speed of the two rotors. The control
takes place with the left control lever. To do this, move it forwards
and backwards in a continuously variable fashion. Contrary to the
other control functions this lever does not spring back into the mid-
dle position. If the control lever is totally drawn towards the back,
then the motors are off and the rotors stand still. If the control lever
is pushed forward then the motor starts running and the rotors run
with increasing speed depending on the lever position.
In the middle position of the control lever, the helicopter should hover at a ¿ xed height.
Tail function
(Rudder function)
The tail function causes a rotation of the model around the vertical axis. Since the helicopter has two opposed rotors, no
torque ensues around the vertical axis at the same speed of the rotors (rotor shaft). The helicopter also therefore requires no
tail rotor for stabilization. In order for the model to be able to rotate around the vertical axis (rotor shaft), the rotors must run
at slightly different speeds. The resulting torque introduces the rotation.
At less speed of the steering rotor compared to the bearing rotor, the torque of the bearing rotor is greater, the helicopter
turns around the vertical axis in the direction of rotation of the steering rotor. At higher speed of the steering rotor, the torque
of the bearing rotor is less than that of the steering rotor and the helicopter turns in the direction of the bearing rotor.
The tail function is controlled with the right control lever. If the lever is moved to the left, the tip of the fuselage turns to the
left. If you move the lever to the right, the tip of the fuselage likewise turns to the right.

Technical data

Principal rotor diameter
Total length
Flying weight
Battery charger with plug adapter
Scope of delivery
- Model built ready-to-À y
- Cabin hood, already mounted
- 2-channel remote control transmitter 27 MHz
- NiMH battery 8,4V/350 mAh
- Battery charger with plug adapter
- 4 piece replacement rotor blades
- Operating Manual
8 CARSON Apache 2CH 507001
350 mm
360 mm
about 237 g
Input: 230 V / AC, 50 Hz
Output: 8.4V/1A
WWW.C ARS ON -MOD E LS P OR T.C OM