Battery Charger - Carson Airbeast 507013 Instruction Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
It is best to fly only in closed rooms
• with a free space of at least 3m in all directions
• on a smooth foundation
• without standing (furniture) or moving obstacles (persons,
animals)
• in rooms without air draught
If you want to fly outdoors, do this
• only when there is no wind,
• at a distance of at least 3 km from the next official model
airplane flying site, otherwise you must make an agreement
about frequency usage.
Transmitter
At first always switch the transmitter on before the receiver is
connected to the battery to avoid any uncontrolled reaction of
the receiver to a foreign radio pulse.
For simultaneous operation of several models, the model may
only be operated on a free frequency.
The same frequency may not be employed when using different
modulation types (FM, PPM, AM, PCM).
Use the frequency streamer on the antenna when you fly with
other pilots.
Rotor
• Damaged rotor blades must be exchanged! Refrain from
attempts at repair!
• Keep away from the rotors, as soon as the battery is
connected.
• Avoid presence in the plane of rotation of the rotors.

Battery charger

Employ exclusively the enclosed battery
charger.
• Operate the battery charger only on fire resistant surfaces
and
• also place the battery on a non-inflammable surface while
charging.
• Ensure for sufficient ventilation of the battery charger while
charging.
011640_anl_507013_airbeast_6k.in5 5
011640_anl_507013_airbeast_6k.in5 5
Do not fly
• if you are overtired or your reactivity is impaired in any way.
• at wind-force 1 or greater
• Keep your model away from high voltage cables or radio
masts.
• Never use the model when lightning is present. Atmospheric
disturbances can affect the signals of your remote
controlling transmitter.
• Choose a sufficiently open & large area; it should be free of
obstacles.
• Always avoid running radio control models in restricted,
confined or populated areas.
• Keep away from roads, highways, people and animals.
After finishing the flight, first disconnect the receiver and the
motor from the battery, and then switch the transmitter off.
The motor can spontaneously start up from an interference
pulse, independent of whether your RC equipment is switched
on or not. The rotor can then cause grave injuries.
The repair of a defective remote-control system may only be
carried out by experts.
The approval of the remote-control system expires if there are
any arbitrary interventions in the electronics.
Do not operate the model while seated, so that you can rapidly
get out of the hazardous area if necessary.
Tighten the retaining bolts of the rotor blades only so much that
in flight these can orient themselves by 180° to each other only
with centrifugal force.
• Never leave the battery charger unattended during the
charging process.
• Never mix fully charged batteries and batteries which have
already run low, or batteries of a different capacity at
the same time.
• When charging the batteries pay attention to the correct
polarity.
CARSON Helicopter Airbeast 507013
GB
5
08.01.2008 9:00:57 Uhr
08.01.2008 9:00:57 Uhr

Advertisement

Table of Contents
loading

Table of Contents