F I T T I N G T H E M O U N T I N G B R A C K E T - Martin Punisher X250 User Manual

R E M O V I N G T H E T R A N S P O R T S E C U R I T Y
P L A T E ( P U N I S H E R O N L Y )
Before first operating the Punisher, you need to remove the transport security
plate inside the unit. This plate holds the mirror assembly during transit, and must
be removed to enable the "shake effect".
1 Remove the top cover from the unit by unscrewing the 4 Phillips screws that
hold it in place.
2 Locate the parabolic mirror assembly in the center of the unit and unscrew
the 4 RED Phillips screws holding the transport plate. Remove the plate.
3 Reassemble the unit.

F I T T I N G T H E M O U N T I N G B R A C K E T

Fit the supplied mounting bracket using the plastic spacers, star washers and
thumbscrews. The star washer must be placed between the bracket and the plastic
spacer.
R I G G I N G T H E U N I T
1 Verify that the structure can support at least 10 times the weight of all
installed fixtures, clamps, cables, auxiliary equipment, etc.
2 If hanging the fixture with a rigging clamp, verify that the clamp is
undamaged and is designed for the fixture's weight. Bolt the clamp securely
to the bracket with a grade 8.8 (minimum) M12 bolt and lock nut, or as
recommended by the clamp manufacturer, through the clamp hole in the
mounting bracket.
3 If permanently installing the fixture, verify that the hardware (not included)
and mounting surface can bear at least 10 times the fixture's weight. The four
small holes and the clamp hole in the mounting bracket may be used for
attachment.
4 Working from a stable platform, clamp or fasten the fixture to the structure.
5 Install a safety cable that can hold at least 10 times the weight of the fixture
through/over the support and mounting bracket.
6 Loosen the thumbscrews, tilt the fixture to the desired angle, and retighten.
7 Verify that the fixture is at least 0.3 meters (12 in.) from the surface to be
illuminated and at least 0.1 meters (4 in.) from any combustible materials.
Verify that the clearance around the air vents is at least 0.1 meters (4 in.).
8 Setup