Toshiba MMU-AP0072H2UL Service Manual page 149

2. Every pushing [Unit, Louver
Specify the indoor unit No. to be replaced.
3. Using the set temperature
4. First change the CODE No. (DN) from
Make a note of the set data displayed in this time.
5. Next change the CODE No. (DN) using the set temperature
Also make a note of the set data.
6. Repeat item 5. and made a note of the important set data as shown in the below table.
01 01 01 01 01 AA AA AA AA AA
∗ to are provided in the CODE No. (DN). On the way of operation, DN No. may skip.
7. After finishing making a note, push
(Approx. 1 minute is required to be able to use the remote controller.)
SET DATA SETTING
TEMP.
3
4
FILTER
RESET TEST
Procedure2: Replacement of service P.C. board
1. Replace the P.C. board with a service P.C. board.
In this time, setting of jumper line (cut) or setting of DIP switch on the former P.C. board should be reflected
on the service P.C. board. Refer to the following table about DIP switch setting and drawing of P.C. board
parts layout.
2. It is necessary to set Indoor unit to be exchanged : Remote controller = 1 : 1
Based upon the system configuration, turn on power of the indoor unit with one of the following items.
1) Single (Individual) operation
Turn on power of the indoor units and proceed to Procedure 3
2) Group operation
A) In case that power of the exchanged indoor unit only can be turned on.
Turn on power of the exchanged indoor unit only and proceed to Procedure 3
B) In case that power of the indoor units cannot be turned on individually. (
a) Remove temporarily the group wire connected to the terminal blocks A and B of the exchanged
indoor unit.
b) After connecting the remote controller wire only to the removed terminal block, turn on power of
the indoor units and proceed to Procedure 3
* When the above methods cannot be used, follow at the
UNIT LOUVER
] button, the indoor unit address in the group are displayed successively.
/ buttons, the CODE No. (DN) can be moved up and down one by one.
10 10 10 10 10
to
TEST
button to return to the usual stop status.
CODE No.
UNIT No.
R.C. No.
ON / OFF
TIMER SET FAN MODE
TIME SAVE VENT
SET CL SWING/FIX UNIT LOUVER
01 01 01 01 01
. (Setting of filter sign lighting time)
/
Minimum requirements for CODE No.
DN
11
12
13
14
2
Capacity of the indoor unit is necessary to set
1
the revolutions of the fan.
CASE 2
149
buttons.
4
Contents
Indoor unit capacity
Refrigerant line address
Indoor unit address
Group address
CASE 1
)
below.
2
3