Toshiba MMU-AP0072H2UL Service Manual page 132

No. Part name
1. Detachment
Fan guard
8
1) Carry out work of Detachment of
2) Remove the screws (2 pcs.) which are fixing
3) Remove the fan guard by removing screws
2. Attachment
1) Using screws, mount the clamp with the fan
2) Fix the fan guard with screws which were
3) Carry out work of Attachment of
1. Detachment
Bottom
9
make-up
1) Carry out works of Detachment of
panel
2) For models of SP240 to 420 class, remove
3) Remove screws at both sides.
4) Remove screws at the fan side.
5) Float the bottom make-up panel downward
NOTE :
Slide the panel horizontally from the drain
pan at discharge side. If you remove the
panel forcibly, it may be broken.
6) When removing base of the sensor part, as
2. Attachment
1) Mount the panel by sliding from discharge
2) Attach the screws (Reinforcement fittings
3) Carry out works of Attachment of
Procedure
the fan guard.
which fix the clamp.
guard.
removed in the work of Detachment of
reinforcement fittings. (M4, 0.39"(10 mm), 1 pc.))
Remove screws at the front side and
remove them from the square hole at the
rear side. The reinforcement bracket is not
provided to models of SP180 class.
(One-side: M4, 0.39"(10 mm), 3 pcs.))
(M4, 0.39"(10 mm), 1 pc.))
while moving it toward the discharge port
direction and then remove the panel.
shown in the following figure, wrap the tip of
minus driver with vinyl tape, insert it into the
groove at the side face under the circle
mark of the cover and then remove the
base by winkling out.
side along the drain pan.
(AP024 to AP042 class only)) which were
removed in the work of Detachment.
.
1
.
2
.
1
and .
7 8
Rear side: Insert into square hole Rear side: Insert into square hole Rear side: Insert into square hole
Reinforcement fittings Reinforcement fittings Reinforcement fittings
Minus driver
(Wrap with vinyl tape.)
Vinyl tape
and .
7 8
132
Remarks
Clamps
Screws
Fan guard
Front side: screwing Front side: screwing Front side: screwing
Screws Screws Screws
Bottom make-up panel Bottom make-up panel Bottom make-up panel
Sensor part base
Insert it into the Insert it into the Insert it into the
groove at side face groove at side face groove at side face
under the circle mark. under the circle mark. under the circle mark.