Electrical Section - Kenwood CKB 250E Instructions For Use Manual

6 - ELECTRICAL SECTION

Before effecting any intervention on the electrical parts the appliance must be
disconnected from the network.
GENERAL
• The connection to the electrical network must be carried out by qualified personnel and
must be according to existing norms.
• The appliance must be connected to the electrical network verifying above all that the
voltage corresponds to the value indicated on the specifications plate and that the cables
section of the electrical plant can bear the load which is also indicated on the plate.
• If the appliance is supplied without a power supply plug and if you are not connecting
directly to the mains, a standardized plug suitable for the load must be fitted.
• The colours of the wires in the appliance power cable may not correspond with the
colours marked on the terminals of your electrical plug. The plug should always be
wired as follows:
– connect the green/yellow wire to the terminal marked with the letter E or the earth
symbol or coloured green/yellow;
– connect the blue wire to the terminal marked with the letter N or coloured black;
– connect the brown wire to the terminal marked with the letter L or coloured red.
• The bi-polar plug must be connected to an outlet connected to the grounding unit in con-
formity to security norms.
• If the oven is to be connected directly to the mains, it must be placed with an omnipolar
switch with minimum opening between the contacts of 3 mm between the appliance and
the mains.
• The power supply cable must not touch the hot parts and must be positioned so that it
does not exceed 75°C at any point.
• Once the oven has been installed, the switch or socket must always be accessible.
• If the power supply cable is damaged it must be substituted by a suitable cable available
in the after sales service.
N.B. For connection to the mains, do not use adapters, reducers or branching
devices as they can cause overheating and burning.
If the installation requires alterations to the domestic electrical system call an expert.
He should also check that the socket cable section is suitable for the power absorbed
by the appliance.
The connection of the appliance to the grounding unit is mandatory.
The manufacturer declines every responsibility for any inconvenience resulting
from the inobservance of this condition.
35