Cleaning & Maintenance - Kenwood CKB 250E Instructions For Use Manual

4 - CLEANING AND MAINTENANCE
GENERAL ADVICE
Important:
Before cleaning or carrying out any
maintenance disconnect the appli-
ance from the electrical supply.
It is advisable to clean when the appli-
ance is cold especially when cleaning
the enamelled parts.
Avoid leaving acidic substances (lemon
juice, vinegar, etc.) on the surfaces.
Avoid using cleaning products with a
chlorine or acidic base.
The oven must always be cleaned after
every use, using suitable products.
ENAMELLED PARTS
All the enamelled parts must be cleaned
with a sponge and soapy water only or
other non-abrasive products.
Dry preferably with a chamois leather.
STAINLESS STEEL SURFACES WITH
ANTI-FINGERPRINT TREATMENT
CAUTION:
The stainless steel front surfaces used
in this oven are protected with a Special
Lacquer to reduce finger-print marks.
To avoid damaging this lacquer, do not
clean the stainless steel with abrasive
cleaners or abrasive cloths or scouring
pads.
ONLY SOAPY/WARM WATER MUST
BE USED TO CLEAN THE STAINLESS
STEEL SURFACES.
Do not use a steam cleaner
because the moisture can get into
the appliance thus make it unsafe.
WARNING
When correctly installed, your product
meets all safety requirements laid
down for this type of product catego-
ry. However special care should be
taken around the rear or the under-
neath of the appliance as these areas
are not designed or intended to be
touched and may contain sharp or
rough edges, that may cause injury.
STAINLESS STEEL AND ALUMINIUM
PARTS AND SILK-SCREEN PRINTED
SURFACES
Clean using an appropriate product.
Always dry thoroughly.
IMPORTANT: these parts must be
cleaned very carefully to avoid scratch-
ing and abrasion. You are advised to use
a soft cloth and neutral soap.
INSIDE OF OVEN
The oven should always be cleaned
after use when it has cooled down.
The cavity should be cleaned using a
mild detergent solution and warm water.
Suitable proprietary chemical cleaners
may be used after first consulting with
the manufacturers recommendations
and testing a small sample of the oven
cavity. Abrasive cleaning agents or
scouring pads/cloths should not be
used on the cavity surface.
NOTE: The manufacturers of this appli-
ance will accept no responsibility for
damage caused by chemical or abrasive
cleaning.
Let the oven cool down and pay special
attention no to touch the hot heating
elements inside the oven cavity.
Do not store flammable material in
the oven.
27