JMC JIMMY 1993 Owner's Manual page 314

Cleaning the Inside of Your Vehicle
Use a vacuum cleaner often to get rid of dust and loose dirt. Wipe vinyl with
a clean, damp cloth.
Your GM dealer has two GM cleaners-a solvent-type spot lifter and a
foam-type powdered cleaner. They will clean normal spots and stains very
well.
Here are some cleaning tips:
e
e
Always read the instructions on the cleaner label.
Clean up stains as soon as you can-before they set.
Use a clean cloth or sponge, and change to a clean area often.
A soft
brush may be used
if
stains are stubborn.
Use solvent-type cleaners in a well ventilated area only. If you use them,
don't saturate the stained area.
If a ring forms after spot cleaning, clean the entire area immediately
or it
will set.
i
Using Foam-Type Cleaner on Fabric
e
e
e
e
Vacuum and brush the area to remove any loose dirt.
Always clean a whole trim panel
or
section. Mask surrounding trim along
stitch or welt lines.
Mix Multi-Purpose Powdered Cleaner following the directions on the
container label.
Use suds only and apply with a clean sponge.
Don't saturate the material.
Don't rub it roughly.
As
soon as you've cleaned the section, use a sponge
to
remove the
suds.
6-48